Mercury Mountaineer 2005 User Manual download pdf (Page 81)

Power door unlock/lock procedure

You must complete steps 1-5 within

30 seconds or the procedure will

have to be repeated. If the

procedure needs to be repeated,

you must wait 30 seconds.

1. Turn the ignition to the 3 (RUN) position.

2. Press the power door unlock control three times.

3. Turn the ignition from the 3 (RUN) to the 1 (LOCK) position.

4. Press the power door unlock control three times.

5. Turn the ignition back to the 3 (RUN) position. The horn will chirp.

6. Press the unlock control, then press the lock control. The horn will

chirp once if autolock was deactivated or twice (one short and one long

chirp) if autolock was activated.

7. Turn the ignition to the 1 (LOCK) position. The horn will chirp once

to confirm the procedure is complete.

Keyless entry key pad procedure

1. Turn the ignition to the 1 (LOCK) position.

2. Close all the doors.

3. Enter factory–set 5–digit entry code.

4. Press and hold the 7 • 8. While holding the 7 • 8pressthe3• 4.

5. Release the 3 • 4.

6. Release the 7 • 8.

The user should receive a horn chirp to indicate the system has been

disabled or a chirp followed by a honk to indicate the system has been

enabled.

SECURILOCK姟 PASSIVE ANTI-THEFT SYSTEM

SecuriLock娂 passive anti-theft system is an engine immobilization

system. This system is designed to help prevent the engine from being

started unless a coded key programmed to your vehicle is used. The

use of the wrong type of coded key may lead to a “no-start” condition.

Your vehicle comes with two coded keys; additional coded keys may be

purchased from your dealer. The dealer can program your spare keys to

your vehicle or you can program the keys yourself. Refer to

Programming spare keys for instructions on how to program the coded

key.

2005 Montego (mgo)

Owners Guide (post-2002-fmt)

USA_English (fus)

Locks and Security

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 263 264

No comments

Mercury Mountaineer 2005 User Manual Page 81