Mercury Mountaineer 2005 User Manual download pdf (Page 80)

Unlocking and locking the doors using keyless entry

To unlock the driver’s door, enter the factory set 5-digit code or your

personal code. Each number must be pressed within five seconds of each

other. The interior lamps will illuminate.

To unlock all doors, enter the factory set code or your personal code,

then press the 3 • 4 control within five seconds.

To open the trunk, enter the factory set code or your personal code,

then press the 5 • 6 control within five seconds.

To lock all doors, press the 7 • 8 and the 9 • 0 at the same time. You

do not need to enter the keypad code first.

Autolock

The autolock feature will lock all the doors when:

• all the doors are closed,

• the ignition is in the 3 (RUN) position,

• you shift into any gear putting the vehicle in motion, and

• the brake pedal is released and the vehicle attains a speed greater

than 5 mph (8 km/h).

The autolock feature repeats when:

• any door is opened then closed while the ignition is in the 3 (RUN)

position, and

• you put the vehicle in motion by releasing the brake pedal and the

vehicle attains a speed greater than 5 mph (8 km/h).

Deactivating/activating autolock

Your vehicle comes with the autolock feature activated. There are three

methods to enable/disable this feature: One is through your dealer, the

second with a power door unlock/lock sequence, and the third with the

keypad.

Before following the activation or deactivation procedures, make sure

that the anti-theft system is not armed, ignition is off, and all vehicle

doors are closed.

2005 Montego (mgo)

Owners Guide (post-2002-fmt)

USA_English (fus)

Locks and Security

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 263 264

No comments

Mercury Mountaineer 2005 User Manual Page 80