Mercury Mountaineer 2005 User Manual download pdf (Page 76)

2. Do not wipe off any grease on the

battery terminals on the back

surface of the circuit board.

3. Remove the old battery. Note: Please refer to local regulations when

disposing of transmitter batteries.

4. Insert the new battery. Refer to the diagram inside the remote entry

transmitter for the correct orientation of the battery. Press the battery

down to ensure that the battery is fully seated in the battery housing

cavity.

5. Snap the two halves back together.

Note: Replacement of the battery will not cause the remote transmitter

to become deprogrammed from your vehicle. The remote transmitter

should operate normally after battery replacement.

Replacing lost remote entry transmitters

If you would like to have your remote entry transmitter reprogrammed

because you lost one, or would like to buy additional remote entry

transmitters, you can either reprogram them yourself, or take all

remote entry transmitters to your authorized dealer for

reprogramming.

How to reprogram your remote entry transmitters

You must have all remote entry transmitters (maximum of four)

available before beginning this procedure.

To reprogram the remote entry

transmitters:

1. Ensure the vehicle is electronically unlocked.

2005 Montego (mgo)

Owners Guide (post-2002-fmt)

USA_English (fus)

Locks and Security

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 263 264

No comments

Mercury Mountaineer 2005 User Manual Page 76