Mercury D2.8L D-Tronic Specifications Page 150

  • Download
  • Add to my manuals
  • Print
  • Page
    / 160
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 149
TROUBLESHOOTING
SECTION 7
Page 142 CMD-4081850 / 90-860094030 SEPTEMBER 2003
0109 with CMD changes
Low Engine Oil Pressure
Possible Cause Remedy
Faulty senders. Have system checked by an authorized
Cummins MerCruiser Diesel dealer /
distributor.
Insufficient oil in crankcase. Check and add oil.
Excessive oil in crankcase (causing it to
become aerated).
Check and remove required amount of oil.
Check for cause of excessive oil (improper
filling).
Diluted or improper viscosity oil.
Change oil and oil filter, using correct
grade and viscosity oil. Determine cause
for dilution (excessive idling).
0111 w / changes in subhead
Battery Will Not Charge
Possible Cause Remedy
Excessive current draw from battery. Turn off non-essential accessories.
Loose or dirty electrical connections or
damaged wiring.
Check all associated electrical
connections and wires (especially battery
cables). Clean and tighten faulty
connections. Repair or replace damaged
wiring.
Alternator drive belt loose or in poor
condition.
Replace and/or adjust.
Unacceptable battery condition. Test battery.
0112 w / changes – CMD
Remote Control Operates Hard, Binds, Has Excessive Free-play Or Makes
Unusual Sounds
Possible Cause Remedy
Insufficient lubrication on shift and throttle
linkage fasteners.
Lubricate.
Obstruction in shift or throttle linkages. Remove obstruction.
Loose or missing shift and throttle
linkages.
Check all throttle linkages. If any are loose
or missing, see authorized Cummins
MerCruiser Diesel dealer / distributor
immediately.
Shift or throttle cable kinked.
Straighten cable or have authorized
Cummins MerCruiser Diesel dealer /
distributor replace cable if damaged
beyond repair.
Improper shift cable adjustment. Have adjustment checked by an
authorized Cummins MerCruiser Diesel
dealer / distributor.
Vacuum leak at shift cylinder, hose or
fittings of Power Shift Assembly, if so
equipped
Repair cut, pinched, or kinked hose or
faulty shift cylinder.
Page view 149
1 2 ... 145 146 147 148 149 150 151 152 153 154 155 ... 159 160

Comments to this Manuals

No comments