MAINTENANCE
SECTION 5
Page 104 CMD-4081850 / 90-860094030 SEPTEMBER 2003
0149.01
Sterndrive Unit and Transom Assembly
1. Lubricate the gimbal bearing through the grease fittings by applying approximately 8-10
pumps of grease from a typical hand-operated grease gun.
77068
a
A
a-Gimbal bearing grease fitting
Description
Where Used Part Number
A
U-joint And Gimbal Bearing
Grease
Gimbal bearing 92-802870A1
2. For propeller shaft lubrication, refer to Propeller.
0150
Engine Coupler
1. Lubricate the engine coupler splines through the grease fittings on the coupler by
applying approximately 8-10 pumps of grease from a typical hand-operated grease gun.
NOTE: If the boat is operated at idle for prolonged periods of time, coupler should be
lubricated every 50 hours.
71569
a
A
a-Engine coupler grease fitting
Description
Where Used Part Number
A Engine Coupler Spline Grease Coupler 92-802869A1
Comments to this Manuals