Mercury 1000 Dual Fuel User's Guide download pdf (Page 25)

INSTALLATION

Check the appliance is electrically safe when you have nished.

Positioning the Cooker

Fig.7-1 and Fig.7-2 shows the minimum recommended

distance from the cooker to nearby surfaces.

The cooker should not be placed on a base.

Above hotplate surround should be level with, or above, any

adjacent work surface.

A gap of 33 mm should be left between each side of the

cooker ABOVE the hotplate level and any adjacent vertical

surface.

For non-combustible surfaces (such as unpainted metal or

ceramic tiles) this gap is not required.

A minimum space of 800 mm is required between the top of

the hotplate and a horizontal combustible surface.

*Any cookerhood should be installed in accordance with the

hood manufacturer’s instructions.

**Any splashback must be tted in accordance with the

manufacturers instructions. Allowance should be made for the

ue trim, which is tted to the cooker hob.

Surfaces of furniture and walls at the sides and rear of the

appliance should be heat, splash and steam resistant. Certain

types of vinyl or laminate kitchen furniture are particularly

prone to heat damage and discolouration.

We cannot accept responsibility for damage caused by

normal use of the cooker to any material that de-laminates

or discolours at temperatures less than 65 °C above room

temperature.

We recommend a gap of 1000 mm between units to allow

for moving the cooker. Do not box the cooker in – it must

be possible to move the cooker in and out for cleaning and

servicing.

A clearance of 90 mm is required if the cooker is near a corner

of the kitchen to allow the oven doors to open (Fig.7-3). The

actual opening of the doors is slightly less but this allows for

some protection of your hand as you open the door.

Moving the Cooker



On no account try and move the cooker while it is

plugged into the electricity supply.



The cooker is very heavy, so take great care.

We recommend that two people manoeuvre the cooker.

Make sure that the oor covering is rmly xed, or removed,

to prevent it being disturbed when moving the cooker

around.

To help you, there are two levelling rollers at the back, and

two screw-down levelling feet at the front.

Remove the polystyrene base pack. From the front, tilt the

cooker forward and remove the front half of the polystyrene

base (Fig.7-4). Repeat from the back and remove the rear half

of the polystyrene base.

90 mm minimum

100

140

180

220

2 2

0 0 0 0 0

100

140

180

220

33 mm

min

800 mm

min

33 mm

min

920 mm

min

945 mm

max

Fig.7-1

Fig.7-3

Fig.7-4

100

140

180

220

2 2

0 0 0 0 0

100

140

180

220

990 mm minimum*

(check cookerhood instructions for actual dimensions)

410 mm

minimum

800 mm

minimum

Fig.7-2

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 35 36

Comments to this Manuals

No comments

Mercury 1000 Dual Fuel User's Guide Page 25

Comments to this Manuals