Mercury KOB WL560 User Manual download pdf (Page 20)

When you first start up your system, go immediately to the Setup Utility to

configure the floppy diskette drives that you have installed. See Standard

CMOS Features on page 26 for more information.

Installing Add-on Cards

This mainboard has five 32-bit PCI (Peripheral Components Interconnect)

expansion slots, one 4xAGP slot, and one Communications and Networking

Riser (CNR) slot.

PCI Slots

PCI slots are used to

install expansion cards

that have the 32-bit

PCI interface.

4xAGP

Slot

The 4xAGP slot is used

to install a graphics

adapter that supports

the 4xAGP specifica-

tion and has a 4xAGP

edge connector.

CNR Slot

This slot is used to

insert CNR cards with

Modem and Audio

functionality.

Note: Before installing an add-on card, check the documentation for the card

carefully. If the card is not Plug and Play, you may have to manually con-

figure the card before installation.

Follow these instructions to install an add-on card:

1. Remove a blanking plate from the system case corresponding to the slot you

are going to use.

2. Install the edge connector of the

add-on card into the expansion

slot. Ensure that the edge con-

nector is correctly seated in the

slot.

3. Secure the metal bracket of the card to the system case with a screw.

Note: For some add-on cards, for example graphics adapters and network adapters,

you have to install drivers and software before you can begin using the add-on

card.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 52 53

No comments

Mercury KOB WL560 User Manual Page 20