Mercury Mountaineer 2001 User Manual download pdf (Page 236)

If the bulb is accidentally touched, it should be cleaned with rubbing

alcohol before being used.

1. With the flat side of the new bulb’s plastic base facing upward, insert

the glass end of the bulb into the lamp assembly. You may need to turn

the bulb left or right to align the grooves in the plastic base with the

tabs in the lamp assembly. When the grooves are aligned, push the bulb

into the lamp assembly until the plastic base contacts the rear of the

lamp assembly.

2. Install the bulb retaining ring over the plastic base until it contacts the

rear of the socket by rotating clockwise until you feel a “stop.”

3. Install the electrical connector into the rear of the plastic base until it

snaps, locking it into position.

4. Turn the headlamps on and make sure they work properly. If the

headlamp was correctly aligned before you changed the bulb, you should

not need to align it again.

Replacing front parking lamp/turn signal bulbs

1. Make sure headlamp switch is in

OFF position, then lift hood and

open the hinged headlamp cover.

2. Remove screw from the lamp

assembly.

3. Disengage lamp assembly.

LIFT

Maintenance and care

236

1 2 ... 231 232 233 234 235 236 237 238 239 240 241 ... 279 280

No comments

Mercury Mountaineer 2001 User Manual Page 236