Mercury Monterey Specifications download pdf (Page 9)

GENERAL ENGINE SERVICE

Section Page

1 Engine Trouble Diagnosis.. 1-2

2 Engine Tests and

Adjustments 1-8

3 Cleaning, Inspection, and

Reconditioning 1-11

Intake Manifold 1-11

Exhaust Manifolds 1-11

Valve Rocker Arm Shaft

Assembly 1-11

Push Rods 1-11

This part covers engine trouble

diagnosis, tests, and adjustment pro-

cedures for all Ford Galaxie and Sta-

tion Wagon engines. In addition, the

Section Page

3 Cleaning, Inspection, and

Reconditioning (Continued)

Cylinder Heads 1-11

Valves 1-12

Hydraulic Valve Lifters.. 1-13

Timing Chain 1-14

Camshaft 1-14

Crankshaft 1-14

Connecting Rods 1-14

Pistons, Pins, and Rings.. 1-14

cleaning, inspection, and recondition-

ing procedures are covered.

For engine removal, disassembly,

assembly, installation, and repair pro-

Section Page

3 Cleaning, Inspection, and

Reconditioning (Continued)

Main and Connecting

Rod Bearings 1-16

Flywheel—Manual-Shift

Transmissions 1-16

Cylinder Block 1-17

Oil Pan and Oil Pumps.. 1-18

Crankcase Ventilation

System Maintenance 1-18

cedures, refer to the part of this

group which covers the applicable

engine.

ENGINE TROUBLE DIAGNOSIS

Engine performance complaints

usually fall under one of the basic

headings listed in the "Engine

Trouble Diagnosis Guide." When a

particular trouble can not be traced

to a definite cause by a simple check,

the possible items that could be at

fault are listed in the order of their

probable occurrence. Check the items

in the order listed. For example,

under "Poor Acceleration," the ig-

nition system is listed as a probable

cause of the trouble. All the ignition

system items that affect acceleration

are listed. Check all these items be-

fore proceeding to the next probable

cause.

ENGINE TROUBLE DIAGNOSIS GUIDE

ENGINE WILL

NOT CRANK

ENGINE CRANKS

NORMALLY, BUT WILL

NOT START

The cause of this trouble is tempt to crank the engine with the

usually in the starting system (Part starter. If the engine cranks, it indi-

11-2).

cates that water is leaking into the

If the starting system is not at cylinders. Remove the cylinder

fault, check for a hydrostatic lock head(s) and inspect the gasket(s)

or a seized engine as follows: and/or head(s) for cracks. Examine

Remove the spark plugs, then at- the cylinder block for cracks.

Check the fuel supply. If there is To determine if the cause of the

sufficient fuel in the tank, the cause trouble is in the primary or the

of the trouble probably lies in either secondary circuit, remove the coil

the ignition or the fuel system. high tension lead from the top of

To determine which system is at the distributor and hold it approxi-

fault, perform the following test: mately 3/16 inch from the cylinder

Disconnect a spark plug wire.

head

with the

ignition on, crank

Check the spark intensity at the end

the engine and check for a spark

of the wire by installing a terminal

If the k at the coil hi h ten

adapter in the termina of the wire to .

{

cau§e f h

be checked. Then hold the adapter , , . ,,,- * ,. .,

approximately %« inch from the ex-

trouble 1S

robabl

in the dlstributor

haust manifold and crank the engine.

cap or rotor

If there is no spark or a weak

IF THERE IS NO SPARK spark at the coil high tension lead,

OR A WEAK SPARK the cause of the trouble is probably

AT THE SPARK PLUGS in the primary circuit, coil to dis-

The cause of the trouble is in the tributor high tension lead, or the

ignition system. coil.

CONTINUED ON NEXT PAGE

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 36 37

Comments to this Manuals

No comments

Mercury Monterey Specifications Page 9

Comments to this Manuals

Related products and manuals for Cars Mercury Monterey