Mercury 2003 Marauder User Manual download pdf (Page 142)

Page 141

WARNING: Do not attempt to operate the vehicle until ALL components are

installed and ALL operations are completed including the final check.

7. FINAL CHECK

7.1. Reconnect the battery

7.2. Check all fittings, nuts, bolts and clamps for tightness. Pay particular attention to

oil and fuel lines around moving parts, sharp edges and exhaust system parts. Make

sure all wires and lines are properly secured with clamps or tie wraps.

7.3. Check all fluid levels, making sure that your tank(s) is filled with 92 octane or

higher fuel before commencing test drive

7.4. Turn the ignition key on. IC pump should run. If you do not see coolant swirling in

the IC reservoir bottle you MUST bleed air from Intercooler cooling circuit (you

need to squeeze all hoses in the IC circuit, especially inlet/outlet hose of Intercooler

pump for couple minutes to completely bleed the air out). For better access you

may wish to remove the splash shield under the front bumper on the side of the

intercooler pump. Add more coolant if necessary.

7.5. Start engine and allow to idle for few minutes, and then shut off.

7.6. Recheck to be sure that no hoses, wires, etc. are near exhaust headers or moving

parts and for signs of any fluid leakage.

7.7. Start the engine. Bleed the air from engine cooling circuit thru the bleeder cap

located on the top of Crossover tube.

7.8. PLEASE TAKE SPECIAL NOTE: Operating the vehicle without ALL the

subassemblies completely and properly installed may cause FAILURE OF MAJOR

COMPONENTS.

7.9. Test-drive the vehicle.

1 2 ... 137 138 139 140 141 142

No comments

Mercury 2003 Marauder User Manual Page 142